Wire Stripping Machine - Wire Crimping Machine

  • Wire Gauge Table - Kingsing Machinery Co., Limited

    2016/06/29

    American wire gauge (AWG), also known as the Brown & Sharpe wire gauge, is a standardized wire gauge system used since 1857 predominantly in North America for the diameters of round, solid, nonferrous, electrically conducting wire. Dimensions of the wires are given in ASTM standard B 258. The cross-sectional area of each gauge is an important factor for determining its current-carrying capacity.
  • World Voltage Standard - Kingsing Machinery Co., Limited

    2016/06/29

    The power supply (voltage and frequency) and the types of outlets differ between countries, there is no international standard. Below is a list of outlet types, if you don't see your destination country mentioned, check the outlet type in Voltage and Outlet Types by Country chart.
  • Terminal Crimping Standard - Kingsing Machinery Co., Limited

    2016/06/29

    Terminal crimping standard includes: bell mouth, bend test, conductor brush, conductor crimp, cut-off tab length, extrusions, insulation crimp, insulation position, strip length, pull force, etc.
  • Terminal Crimping Force Standard - Kingsing Machinery Co., Limited

    2016/06/29

    Crimp height is usually control charted because it is a quick, nondestructive measurement and is critical for the termination's electrical and mechanical reliability.
Prev1Next Go to