Automatic Wire Stripping and Crimping Machine - KINGSING

  1. Home page
  2. Services
  3. Industry News

How can ordinary workers correctly use the automatic terminal machine?

2022-11-22 13:23:05 美工

The automatic terminal machine is mainly used for the processing of the wire industry. Therefore, if we buy a good terminal machine, it will help enterprises save a lot of costs. Because the automatic terminal machine is used now, it can also help enterprises save a lot of manpower, thus improving the performance of enterprises. Therefore, how to use the automatic terminal machine correctly is very important, but usually there are not so many senior engineers in the factory to maintain the terminal machine? Now we will introduce the correct posture and abnormal handling of ordinary workers using the full-automatic terminal printer.

At present, most of the terminal machines are automated, so it is very convenient to operate. However, we still need to read the manual carefully, especially for novices, we must ensure the correct operation mode of the terminal machine. First, check whether the power supply meets the standard, and then turn on the switch to operate the terminal machine when everything is checked correctly.

Under the normal operation of the terminal machine, the terminal machine may not work normally for some reasons. At this time, we need to cut off the power supply first, and then contact the maintenance personnel to help us check and debug. Do not repair the terminal machine yourself, because the parts on many parts of the terminal machine are very sharp. If we are not careful, accidents will occur.

From the above, we can see that when the factory has purchased the full-automatic terminal machine, it does not need to be specially equipped with senior engineers. Only by using the simple method of appeal, ordinary workers can also operate the full-automatic terminal machine. In case of abnormality, it would be better to go directly to the manufacturer of the full-automatic terminal machine. It does not necessarily cost a lot to hire a full-time full-automatic terminal machine maintenance engineer alone!