Automatic Wire Stripping and Crimping Machine - KINGSING

  1. Home page
  2. Services
  3. Industry News

The reason why the wire cutting and stripping machine cannot be started normally

2022-11-28 14:30:43 美工

The wire cutting and stripping machine is the same as all products. After a long period of use, there will be various problems. One of them is the inability to start the machine. Here we will introduce the reasons why the wire cutting and stripping machine can not start. The details are as follows:

1. Correct power input

For almost all products connected to the power supply, the first thing to consider is the power input when they cannot be started normally. Some people may say that this kind of problem usually does not occur, but according to customer feedback, it is precisely this kind of situation that occurs most. For some equipment, for safety reasons, the socket is not grounded, which may lead to power input problems. Therefore, when the wire cutting and peeling machine cannot be started, first check whether the socket, power cord and port are normal to ensure that there is no problem with the power input.

2. Internal circuit path of wire cutting and peeling machine

The on-off of the circuit is the most direct factor affecting whether the wire cutting and peeling machine can be started normally. In the first case, the operator can detect the circuit. This circuit detection may require the cooperation of the electrician and the supplier's after-sales department. In order to protect the performance of the equipment, it may need to be returned to the factory for maintenance.

3. The display screen of the wire cutting and stripping machine is intact

When the display screen of the wire cutting and peeling machine is turned on and cannot display data, and there is no problem with the power supply and circuit, it may be that there is a problem with the display screen. In this case, it is recommended to contact the supplier to provide the original display screen, and complete the display screen replacement or return to the factory for maintenance under the guidance of the supplier.