Automatic Wire Stripping and Crimping Machine - KINGSING

  1. Home page
  2. Services
  3. Industry News

Installation and Use Guide of Full Automatic Double Head Waterproof Plug Ending Machine

2022-11-30 14:44:18 美工

How to install and use the automatic double head waterproof plug end printer?

1. Before installing the automatic double head waterproof plug end machine, check the tightening of the upper and lower die blades and the feeding fastening screws.

2. Pull up the slider of the automatic double head waterproof plug end striking machine mold, and cover the sliding groove on the 2000 type handle, or (insert the power supply, press the adjustment button, and rotate the rear axle counterclockwise with an open-ended wrench to make the press slide down quickly, and cover the automatic double head waterproof plug end striking machine mold sliding groove on the 2000 type handle).

3. The mold base plate of the full-automatic double head waterproof plug end striking machine and the work table of the compactor are fixed with pressing plate fixing screws. The mold of the full-automatic double head waterproof plug end striking machine cannot be loosened (under normal circumstances, the mold of the full-automatic double head waterproof plug end striking machine cannot be loosened under normal circumstances).

4. After the mold of the full-automatic double head waterproof plug end beater is installed, manually rotate the rear shaft counterclockwise with an open wrench to observe whether the lower mold blade is central and vertical.

5. Adjust the pressure and press it up and down.

6. The terminal guide plate is installed on the full-automatic double end sheath threading terminal. After the die feeding tray, properly adjust the terminal pressure screw to prevent the terminal from retreating during normal operation.

7. Manually test the terminal, and observe whether the feeding head can be sent to the center of the upper and lower die normally.

8. Pressure test shall be conducted after the automatic double head waterproof plug end beater is adjusted, and tensile test shall be conducted after 10 times of pressure test. If it is qualified, production shall be conducted, and problems shall be found and corrected.