Automatic Wire Stripping and Crimping Machine - KINGSING

  1. Home page
  2. Services
  3. Industry News

Causes of the wire deviation of the wire cutting and peeling machine

2022-12-29 15:48:43 美工

The problem of wire deviation from the wire cutting and peeling machine is common. For the wire cutting and peeling machine, there are two reasons for this situation, one is the centering module, the other is the wire clamping part. Let's talk about it in detail as follows:

1. The centering module determines the exact position of the wire stripping. If the centering module has a problem and causes core deflection, the wire core may be damaged on one side and the wire core may not be completely peeled on the other side.

2. The main reason for deviation at the thread clamping part is the clamping claw. There are sundries on the clamping claw, and the clamping claw is not in correct position, which will cause the deviation of stripping wire. In addition, this also happens when the screws that fix the clips are loose, which indirectly causes jaw problems.

3. For the wire cutting and peeling machine, the phenomenon of deviation is mainly related to several factors, such as blocking, wire harness itself, conduit and wire feeding wheel.

4. Blocking may lead to harness deviation: harness itself is not straight, harness quality and other problems may also lead to peeling deviation: catheter is not straight, catheter is not centered, wire feeder is loose and other equipment problems caused by equipment itself or in the later use process may also lead to harness deviation.

5. In addition, since it is a peeling problem, it is naturally inseparable from the tool rest. The offset of the tool rest, the wear of the blade, and the looseness of the fixed part of the blade will lead to the line deviation of the wire cutting and peeling machine.

6. When the wire deviation of the wire cutting and peeling machine occurs, first determine the position of the deviation. According to the deviation of the wire, preliminarily judge the possible reasons for the deviation, and then conduct troubleshooting. If the deviation still exists, a new wire can be used to test the machine.