Automatic Wire Stripping and Crimping Machine - KINGSING

  1. Home page
  2. Services
  3. Industry News

Reasons for the failure of the coaxial stripping machine

2022-10-13 11:32:45 美工

KINGSING

1.The wire can not be stripped:

  • Check the laser cutting depth of the wire, and adjust the diameter of the cable to reduce it.

  • The gap of the three-phase five-wire transmission wheel is too large, adjust the gap of the three-phase five-wire transmission wheel.

  • Whether the setting of the stripping head exceeds 3mm.

  • There is dirt in the threading pipe.

  • The feed setting is very large and needs to be reduced.

2. The tail of the wire cannot be peeled off:

  • Check the laser cutting depth of the wire, and adjust the diameter of the cable to reduce it.

  • If the gap of the group outlet transmission wheel is too large, adjust the gap of the group outlet transmission wheel.

  • Whether the setting of the stripping head exceeds 3mm.

  • The feed setting is very large and needs to be adjusted down.

3. The outer skin of the wire is crushed:

  • Adjust the gap between the three-phase five-wire transmission wheel and the group outlet transmission wheel.

  • Contact the manufacturer of the coaxial wire stripping machine to remove and replace the transfer wheel.